|
Blue Fae Passion
Tools needed
PSP- I used PSP X but it should work with all.
Filters Used: Eyecandy-Gradient Glow
Tube/Image of choice: I used the art of Joel Adams who is a PTU artist. You MUST have a license to use his art. You can purchase his art from CILM.
Font/s of choice: I used Monotype Corsiva.
Scrap Embellishments of choice: I used a butterfly,flower and wordart I purchased in a kit from Designer Scraps. All were made by Farrah
Lets get started!!!
1.Open a new Image 400 X 500 transparent
2. Select your rectangle preset, foreground color from tube, backgound blank and a width of
3. Draw out a large rectangle, see my tag for reference, convert to raster
4. Duplicate and resize by 80#
5. Give each rectangle a drop shadow of 1,1,40,2.50 Black and -1,-1,40,2.50 Black
6. On your bottom layer, go to select all, float, defloat
7. Layers, new raster and paste into select paper of choice, Select none.
8. Magic wand inside of the bottom rectangle , Selections, modify, expand by 3.
9.Layers, new raster layer, copy paper of choice and paste into selection.
10. Select none and move the paper below.
11. Repeat steps 8,9 and 10 on your smaller rectangle.
12. Now give each rectangle a gradient glow of choice. I used eyecandy 3
13. On each rectangle, give it some noise. using adjust, add/remove noise.
14. Copy and paste your tube of choice as a new layer, position and resize if necessary
15. Add some scrap embellishments of choice.
16.Add your � Information
17. Add your text and anywordart of choice.
18. File save as.
Your Done!!
Thankyou for trying this tutorial
This Tutorial was written on the 12th September 2008 by Mell aka Babylicious36
ALL TUTORIALS ARE REGISTERED WITH TWI.
This tutorial is written using my imagination and is in no way copied from any other tutorial. Please do not Steal.. You may print this out for future use.
This page was assembled by Mell aka Babylicious36
Artwork �Joel Adams www.lilz.net CI-1060LM | 