|
|
|
|
|
|
|
|
|
|
|
|
|
| Spring Install Page 2 | ||||||||||||
|
||||||||||||
| OK, heres where stuff can get trickey without a spring compressor. What you want to do is jack up the entire assembly very slowly while you center the top of the strut to go through the strut tower. Now put that center nut back on the strut tower, hold the male part of the strut and tighten it down good with the impact. That part can take some time, but with patience its not too hard. | ||||||||||||
| Now repeat these step on all four corners. The rear is slightly more complicated becuase before removing the strut you have to remove the sway bar linkage from its connection to the strut, and be sure to reattatch it to the strut. Thats all there is to it. | ||||||||||||
| Back To Installs | Home | |||||||||||