Geopathic Stress Accelerator
Rather than hold back or neutralise geopathic stress this device acts to accelerate the negative energy through a building thereby reducing the width of the geopathic stress path.
In the initial development the width of geopathic stress paths was reduced by 50%, from around 4ft to something like just over 2ft.
By adding crystals to absorb the negativity a further reduction of around 6in. was made.
In the last phase of the development the energy was focused on these crystals and a Tachion bead added to bring in positive energy, this reduced the negative effects of the geopathic stress path to only a few inches. The path was also drawn to the Geopathic Stress Accelerator and away from people living in the building.
The device is simple to make and consists of:
A length of plastic waste pipe with two spirals of 2.5mm copper wire wound around it. Each spiral starts from the base 180 degrees (opposite) each other. The pitch of the spiral is based on the Earth/Moon ratio of 11/3. The spirals run anti clockwise.
Topped by a pyramid made of 1.5mm copper wire.
Two 1/4in thick quarts crystals held at the base against the two main spirals. This was done using 1.5mm copper wire cones wound anti clockwise. They both point towards the top.
At the base and top two large 1in thick quarts crystals pointing towards the top.
A sprung cone of 2.5mm copper wire which has a black pouch inside it is pushed up half way inside the tub, the tail of the cone being bent out to grip the inside of the tub preventing it slipping down. The pouch contains 2/3 pieces of obsidian and a tachion bead.
All crystals are cleaned and blessed.
The lines of geopathic stress are located by dowsing and measured before and after installing the Geopathic Stress Accelerator.
The Geopathic Stress Accelerator is placed on a wall or in a cupboard in the geopathic stress path. If two lines cross then it can be placed at this point so affecting both paths. The tube is positioned so a face of the pyramid faces North.
The unit can be further activated by spiralling energy from its base to the top.
This information may be freely passed on for the good of humanity.
The Geopathic Stress Accelerator described here may not be made and sold for profit. Geopathic Stress Accelerators can be hand made and installed to order by contacting David Hunt on 0973 128 176.
Copyright - David Hunt Personal Growth and Development - June 1998