REFERENCES

A. OPNAVINST 4790.2E, NAVAL AVIATION MAINTENANCE PROGRAM, VOL I
B. NAVEDTRA 12011-A, AVIATION MAINTENANCE RATINGS SUPERVISOR

116.1 DEFINE THE WORK CENTER SUPERVISOR'S RESPONSIBILITIES. REF A

A. ENSURE ACCOMPLISHMENT OF ALL ASSIGNED WORK.

B. MAXIMUM UTILIZATION OF PERSONNEL AND FACILITIES.

C. MAKE RECOMMENDATIONS ON WORK CENTER REPAIR CAPABILITIES AND FACILITY REQUIREMENTS.

D. CAUSE ALL WORK TO BE INSPECTED AS REQUIRED.

E. INITIATE MATERIAL REQUIREMENTS TO SUPPORT WORK LOAD.

F. SCREEN ALL SOURCE DOCUMENTS, WORK REQUESTS AND APPLICABLE RECORDS AND REPORTS TO ENSURE ACCURACY, COMPLETENESS AND TIMELINESS OF SUBMISSION.

G. INFORM MAINTENANCE CONTROL AS TO WORK STATUS.

H. REVIEW DAILY MAINTENANCE DATA REPORTS (MDR'S) FOR ACCURACY AND SUBMIT NECESSARY CORRECTIONS.

I. ENSURE THE MAINTENANCE DEPARTMENT'S TRAINING PROGRAM IS PROPERLY SUPPORTED WITHIN THE WORK CENTER.

J. ENSURE THE EXPEDITIOUS RETURN OF COMPONENTS AND APPLICABLE RECORDS/LOGS TO MATERIAL CONTROL.

K. ENSURE WORK UNIT CODE MANUALS AND OTHER PERTINENT PUBLICATIONS ARE AVAILABLE TO ALL WORK CENTER PERSONNEL.

116.2 WHAT ARE THE RESPONSIBILTIES OF THE WORKCENTER SUPERVISOR IN REGARDS TO: (REF B)

A. TOOL PROGRAM - ENHANCEMENT OF FLIGHT SAFETY BY ELIMINATING ACCIDENTS ATTRIBUTED TO LOST TOOLS. NOTES THE TOOL POUCH NUMBER ON VIDS/MAF TO LEFT OF WORKER'S NAME, AND CONDUCTS A SIGHT INVENTORY, BEFORE, DURING AND AFTER TASKS.

B. IMRL - EQUIPMENT AND TOOLS TO HAVE ON HAND TO WORK ON AIRCRAFT.

C. QA - MONITOR AND MANAGE PROGRAMS. EVALUATE AND TEST AND AUDIT.

D. PMS - CONDUCT SCHEDULED MAINTENANCE (SPECIAL MAINTENANCE).

E. CALIBRATION - COMPARING AND ADJUSTING SE PERFORMANCE TO CALIBRATED STANDARDS.

F. SE - ONLY PERSONNEL PROPERLY LICENSED OPERATE SE.

G. CORROSION - PREVENT AIRCRAFT ACCIDENTS, INCIDENTS, EXCESSIVE OUT OF SERVICE TIME, SERIOUS DAMAGE, REDUCTION IN READINESS.

H. FOD PROGRAM - RAPIDLY ACCOUNT FOR ALL TOOLS, SAVE LIVES AND EQUIPMENT BY ELIMINATING TOOL FOD CAUSED ACCIDENTS.

I. OIL & HYDRAULIC CONTAMINATION - ACHIEVE AND MAINTAIN SATISFACTORY LEVEL OF FLUID PURITY IN HYDRAULIC SYSTEMS.

J. HM/HW - HAZARDOUS MATERIAL/HAZARDOUS WASTE

K. MTIP - MAINTENANCE TRAINING IMPROVEMENT PROGRAM - RATE SPECIFIC TEST.

L. AUDITS - PROVIDE EVALUATION OF PERFORMANCE THROUGHOUT DEPARTMENT, SERVING AS ORDERLY METHOD OF IDENTIFYING, INVESTIGATING AND CORRECTING DEFICIENCIES.

M. VIDS/MAF - VISUAL INFORMATION DISPLAY SYSTEM/MAINTENANCE ACTION PLAN

N. TRAINING - MAINTAIN LEVEL OF KNOWLEDGE; SCHEDULED IN MMP.

116.3 DEFINE THE FOLLOWING AS APPLIED TO AVIATION MAINTENANCE. (REFS A,B)

A. IPB - ILLUSTRATED PARTS BREAKDOWN MANUAL. ALSO KNOWN AS ILLUSTRATED PARTS LIST OR CATALOG, IS PREPARED BY MANUFACTURER FOR EACH MODEL AIRCRAFT, ENGINE, ACCESSORY, ELECTRONIC EQUIPMENT OR SUPPORT EQUIPMENT.

B. MIMS - MAINTENANCE INSTRUCTION MANUALS - CONTAIN INSTRUCTIONS FOR "O" AND "I" LEVEL MAINTENANCE AND SERVICING OF A SPECIFIC MODEL AIRCRAFT. MIMS IDENTIFIES EACH MAINTENANCE TASK TO THE RESPONSIBLE MAINTENANCE LEVEL.