INSTALLING A BILLET TB PLATE

Start buy removeing the six OEM TORX screws holding on the old TB plate with your T-20 bit. Pull old the old plate and black rubber gasket.

As you can see from the pic there is a differance in the old and new gaskets. My old one was in pretty bad shape so I went with the new one.

Place the gasket (new or old) back on the throttle body so all the holes line up. Put the TB plate back where you took of the old one. Put some "LOCK-TITE" on your new screws and put them in one at a time, but do tighten them completly until they are all in place.

Now just tighten them snug and your done. Don't it look great!!!