LEFT: Dan upgraded the positive and ground alt. wires with 0 gauge wire from
Tsunami.
CENTER: The engine and chassis grounds were upgraded with 0 gauge. This increased voltage by 3/4 of a volt.
RIGHT: This is the car with the interior out of it before anything was done.
LEFT: Here Dan is cutting a hole to run the power wire.
CENTER: This is the
Tsunami
power and ground wire that will be used. This is a high quality product.
RIGHT: Here you can see how Dan routed the 0 gauge power/ground wire though to the rear of the car.
LEFT: Here you see how the
Tsunami
RTP900 series rca's are run through the car.
CENTER: Here's a better picture of the twisted pair rca audio cables.
RIGHT: Here you can see how Dan sound deadened the inside of the car with SS705 from
Tsunami.
LEFT: Here's you can see the stock door with the panel removed.
CENTER: Here's the rear tray. Something needed to be done here because of the subs. It's pretty thin.
RIGHT: Dan decided to glue a layer of acoustic foam to the rear tray because it was easier to apply here.
LEFT: The lock-nut terminal ends from
Tsunami
are pretty cool. No crimping needed.
CENTER: The SW900 series 14 gauge twisted pair speaker wire is used though out the car.
RIGHT: There will be 2 PP910FM-CAP
Tsunami
power pumper capacitors with monitor tops.
Dan has 2 of these monsters. They are the
Streetwire
1050 power station batteries with the silver terminals and fusing at the battery.
Next Page
Buddah's Home
Page 6
