1975 Duster was slant 6, now 360
Still has /6 torsion bars.
This is an Andy Mayes built 360.
360 Block, 0.030 over, line honed, square decked and honed with plates,
Weisco flat top pistons. Pistons set .010 in the hole for around 11:1 compression.
Rods polished and shotpeened. Assembled using ARP bolts. File fit rings
Cam is 292 509 Mopar Performance cam, degreed into the block
and installed on 106 degree centerline, Double roller timing chain
J Heads ported & polished with Manley 2.02 1.60 valves
with comp springs and Comp pushrods
Edelbrock Performer manifold with Holley Street Avenger carb
New headers/exhaust/flowmaster mufflers
Transmission has a small stall convertor and has been rebuilt with a reverse
manual valve body. Has a B&M Prostick shifter installed.
Rear end has a spool, 3.91 gears, long studs, mosier axles, mopar 8 3/4.
Interior is very nice, rubber floor mats, bench seat interior.
Car is in need of paint. It is still white, but shows signs
of needing repairs. Runs fantastic!
You may call Andy Mays of Mays racing for further info on this
engine/tranny/rear end because he built it all.
Located in Nashville
$6,000
e-mail [email protected] for more info.
Side view
Another Side view
Engine
Drivers Side Engine View
Pass Side Engine
Front view
Rear View
Interior view
Interior view
