I finally decided to have my car dynoed after all of the previous mods. I haven't scanned the chart yet so I'll just have to post the numbers instead. I had 3 runs but the guy only printed the 1st and 3rd. The 2nd was the same as the 1st anyways.
1st Run, AFPR set at 50 psi:
236 HP @ 4500 RPMs & 325 ft-lbs @ 3600 RPMs
2nd Run, AFPR set at 48 psi:
245 HP @ 4500 RPMs & 335 ft-lbs @ 3700 RPMs
Remember that these are readings at the rear wheels so you can account for a 20% drivetrain loss with an auto tranny. This equates to roughly 305 HP and 415 ft-lbs at the crankshaft. The guy also didn't start the run until AFTER my torque peak because after the 2-3 shift it was right at 3600 RPMs. TPI's peak torque usually comes at 3200 RPMs so it should read higher. As far as the FP is concerned, I feel that it may have ran even stronger with 46 psi but I didn't get the chance to test it.
