Name
     mmount - mount an MSDOS disk

Note of warning
     This manpage has been automatically generated from  mtools's
     texinfo  documentation,  and may not be entirely accurate or
     complete.  See the end of this man page for details.

Description
     The mmount command is used to mount an MS-DOS  disk.  It  is
     only available on Linux, as it is only useful if the OS ker-
     nel allows to configure the disk geometry. Its syntax is:

     mmount msdosdrive [mountargs]

     Mmount reads the boot sector of an MS-DOS  disk,  configures
     the  drive geometry, and finally mounts it passing mountargs
     to mount. If no mount arguments are specified, the  name  of
     the  device  is  used. If the disk is write protected, it is
     automatically mounted read only.

See Also
     Mtools' texinfo doc

Viewing the texi doc
     This manpage has been automatically generated from  mtools's
     texinfo documentation. However, this process is only approx-
     imative, and some items, such as crossreferences,  footnotes
     and  indices  are lost in this translation process.  Indeed,
     these items have no appropriate representation in  the  man-
     page   format.   Moreover,  not  all  information  has  been
     translated into the manpage version.  Thus I strongly advise
     you  to  use  the original texinfo doc.  See the end of this
     manpage for instructions how to view the texinfo doc.

     *    To generate a printable copy from the texinfo doc,  run
          the following commands:

                 ./configure; make dvi; dvips mtools.dvi



     *    To generate a html copy,  run:

                 ./configure; make html

          A     premade     html     can     be     found     at:
          `http://mtools.linux.lu'       and       also       at:
          `http://www.tux.org/pub/knaff/mtools'

     *    To generate an info copy (browsable using  emacs'  info
          mode), run:

                 ./configure; make info



     The texinfo doc looks most pretty when printed or  as  html.
     Indeed,  in  the info version certain examples are difficult
     to read due to the quoting conventions used in info.