Build notes - IP-84 Devastator (Hilt) Fighter

This model has two 'errors' in it due to LDraw not yet having the proper
parts available.

1.  The engines are attached to four 1x2 Technic beams with holes.
These should be two approximately 45 degree angled 1x4 Technic beams
with standoffs found in the small Technic hovercraft model.
It is possible to substitute normal Technic 1x4 beams with a little
creative remodeling. Or possibly use flat hinge pieces in the existing
design with the four 1x2 beams.

2.  Flexible hoses should connect from a Technic pin inserted into the
inboard hole of each of the above engine blocks to the 1x1 bricks with 
side studs located aft of the cockpit canopy.

I also did not finish the interior of this model - use your imagination! 

Terrell Keller