Build notes - Star Wars E-Wing Starfighter

This model has one error in it due to LDraw not yet having the proper
part available.

1.  The octagon column pieces used for the body of each engine. My model
uses column pieces with two 2x2 plate studs attached at a right angle to
the column piece. I had to substitute two plain columns and then added
two 2x2 round plates on the sides. 
Looks almost exactly right :-)

I left a fair sized compartment behind the cockpit - this is where the
R7 series astromech droid is installed.  Use your imagination!
To open the cockpit, grip tightly behind the canopy below the dorsal
laser, and lift/pry carefully upward.

The cockpit will fit -tightly- a Technic figure.
But the poor guy must be built in! 

The holes on the belly of the craft are there for a reason.  The forward
central hole below the cockpit is the mount point for the BIG Ion Cannon.
The aft hole (the front one of the three) is a mount for the model stand
using a technic axle piece.

Have Fun!

Terrell Keller